What it is
The Self-Adjusting Shuttle is
an accelerating/decelerating back-and-forth reversing unit with complete hands-off operations. The SHUTTLE will sense the ends of the track and self-adjust to provide a very realisitic slow down and then creep to a stop.
The track ends are sensed with a track isolator and a diode.
In-between station stops are possible with the addition of train sensors and a magnet on the train.
The Shuttle is available in two configurations; a V3 simple version for most setups, and a V2 advanced version for multiple train operations and tweaking controls.
The
Shuttle can control trains up to 5 AMPS, however there is no limit on the input power rating. The input power can be either from a DC model train throttle, or an inexpensive fixed voltage DC power supply. DC trains will run right out of the box, however DCC trains can be controlled when used with a "PWM to DC" conversion unit, or when the DCC decoder is bypassed. Depending on the DCC decoder, sometimes it just works without doing anything at all.
In addition to fully automatic mode, the SHUTTLE V2 version can also be run in manual mode which allows full manual control of the reversing operation. This is sometimes necessary for Z or N scale trains. |